Upcycled Capelet Tutorial . Part II

First of all, thanks so much for all the positive feedback on this capelet. And thanks again to Kathleen of Grosgrain for designing the original pattern. It is such a great fit.

For Part I of the tutorial, click here.

We will begin with the lining.

Hem the straight edge of the FRONT lining pieces (shown above but covered with the next step). To figure out how much to turn in, place these pieces on the jacket fabric and measure. I turned the button edge in 3/8” as that is the seam allowance. But for the buttonhole side, you will need to leave room for the buttonholes and turn in more (see arrows). This measurement will depend on your jacket’s original buttonholes.

Take your warm fleece fabric for the muff/pouch and turn all four edges under ½” and stitch. If your fabric won't fray much, you could probably avoid this step. Or if you have a serger, that would be even better.

Place the fabric panels on the wrong side of the lining as shown. They should butt up against the edge. Topstitch them on taking care not to get the lining all bunched up.

Stitch the FRONT and BACK cape pieces RST at the long curved seam. Don't forget to leave the armhole open. Backstitch for extra strength at those points. On the original pattern there are marks and notes, "sew to here." I will make a note to myself by putting a pin in the other direction where I need to stop.

Stitch the FRONT and BACK lining pieces RST at the long curved seam. Leave the armhole open as before.

Remove the buttons and mark their placement. You will sew them back on later.

Next the place the lining inside the cape RST.

Prepare the hem. You will need to turn the existing flap of the jacket to the outside to ensure a clean edge. Then pin the entire hem and stitch carefully.

Stitch the collar to the lining RST, making sure to leave the neck edge open.

Clip both points off as shown. Turn inside-out and press.

Set the collar inside the cape RST as shown. The inside of the cape (the wrong side) will be facing outward and the collar will be nestled inside. Make sure that you attach the collar lining to the jacket fabric. Likewise, the cape lining will be attached to the jacket fabric. Then pin like you’ve never pinned before, starting with your center folds. Stitch carefully. If you get a pucker, just pick out the stitches around it and sew that area again.

Now the fun part. Pull the whole thing inside-out through one of the front openings.

Topstitch your neck seam so that it will lie flat.

Now finish up the construction by topstitching the lining to the cape. Leave an opening as shown so that the chubby little fingers can clasp on crisp Fall days.

Your buttonhole side should have the lining stitched just outside the edge of the original buttonholes. If you have a weighty tweed like the one pictured, your stitching will not show very much on the front of the capelet.

Finger press your bottom hem, pin and topstitch about ¼” from the edge.

Sew the buttons back on. Attach the hook and eye closure.

And it’s done! Please let me know if you have any questions. I know that a few of the photos are less than stellar. I am happy to try to fix any problems in the post.